|Published (Last):||17 June 2006|
|PDF File Size:||20.77 Mb|
|ePub File Size:||15.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
BenQ PB2240 User Manual
Lamp Information Mamual Information Warning Message When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. According to the selected input signal, there are several picture Preset setup options available: Turn all equipment off before making any connections. Lamp Information Warning Message When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer.
Safety Instructions Continued 7. Liquids spilled into the projector may cause it to fail.
Do not beq this product on an during operation. The selected source will be displayed at the bottom right of the screen for 3 seconds.
The final warning will flash in the center of the BenQ PB projector for 40 seconds and then shut down for good. The Power indicator light flashes orange and the lamp shuts down, the fans continue to run for approximately 90 sec- onds to cool down the projector.
CG1 projector lamp The lamp cover is found on the pn2140 of the projector. The start up procedure takes about 30 seconds after pressing Power.
BenQ Projectors: BenQ PB DLP projector
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications.
Contact your dealer if other parts needs replacing.
Page 6 This product is capable of displaying inverted images for ceiling mount installation. Insert the new BenQ Leave a Reply Cancel reply Your email address will not be published. Bemq to page 23 for more information.
Turns the projector on manuak off. If any of these items are missing, please contact your place of purchase. Three modes are available: Do not place liquids near or on the pro- jector. There are 10 different menu languages. Source Selection Source Selection To sequentially select input sources, press the Source key on the projector control panel or the remote maanual.
Mobile pbMobile pb Shutdown Shutdown Press Power and a warn- ing message appears. No part of this publication may be repro- duced, transmitted, transcribed, stored in a retrieval system or translated into any language or com- puter language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
Table of Contents Add to my manuals Add. Adjusting the Height The projector is henq with 1 quick-release adjuster foot and 2 rear adjuster feet. It occurs when the projector is not perpendicular to the screen. Switch all of the connected equipment on. To adjust the projector, 1. Connection When connecting a signal source to the projector, be sure to: Copyright Copyright by BenQ Corporation. Things you have to do on a regular basis are keep the lens clean.
This site uses Akismet to reduce spam. Adjusting the Height The projector is equipped with 1 quick-release adjuster foot and 2 rear adjuster feet.
Color Adjusts the color tones of the image. Replacing the BenQ Lift the projector up and press the adjuster button to release the adjuster. Refer to page 20 for more information. Operation Start Up 1. Turn all equipment off before making Carefully unpack and verify that you have all of the items shown below.
The higher the value, the more red- dish the image becomes. This product is capable of displaying inverted images for ceiling mount installation.
Table of Contents Important Safety Instructions Cleaning the Lens Clean the lens whenever you notice dirt or dust on the surface. Power indicator light Refer to page more information.